Bosch Rexroth CS550 - Connector Details; Microcontroller Connection; Solenoid Connection

10/20
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
6 Connector Details
6.1 Microcontroller Connection
1. Extend sliding tabs.
2. Partially insert connector into socket and ensure the 4 coding posts align into housing.
3. Push sliding tabs in and the connector will fully insert and lock itself.
4. To remove, pull the tabs out and the connector will un-mate.
Note: The RC4-4 “Spreader” controller uses only the larger connector, while the RCE
“Joystick” controller uses both.
6.2 Solenoid Connection
1. Push on the connector to mate.
2. Press metal retainer to un-mate.