Bosch Rexroth CS550 - Main Harness Connections

12/20
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
7.2 Main Harness Connections
All 2 POSITION MOLDED CONNECTORS with diagnostic LEDs are for solenoids. Each
leg has a function label.
Note: Valve extensions are required if the microcontroller is mounted in the cab (see page
7, note 4, 5).
• All 5 POSITION THREAD-ON connectors are for sensors.
• The 8 POSITION THREAD-ON connectors are for CANBUS and auxiliary digital
inputs. (See layouts on pages 4 to 6.)
• See system layout for Auxiliary Cable and Remote Pause/Blast.
• See installation notes for routing details (page 15).
• See function chart for connection details (page 13, 14).