Bosch Rexroth CS550 - Page 6

6/20
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
The following is a detailed navigation chart for the system layout. See Appendix for the
detailed system layout including all the components and part numbers.
CS-550 / 150 ELECTRONIC SYSTEM BUILDER
TABLE OF CONTENTS
COORDINATES
ITEM DESCRIPTION X.Y DETAILS
550 SPREADER
1 SPREADER PACKAGES E1 DISPLAY AND RC INCLUDED
2 MAIN HARNESS D7 ADVANCED OR LITE
3 CANBUS CABLES C2
4 SENSOR EXTENSIONS B6
5 SENSOR NETWORK C6 PULL-UP RESISTOR (WHITE MOTOR)
6 VEHICLE SPEED B7
7 VALVE EXTENSIONS E6 IF RC LOCATED IN CAB
8 550 AUXILIARY CABLE E3 MATERIAL DETECT / CHANGE
9 VALVE ADAPTER E6 (C4M TO ITT) FOR OLD SCB/MP18
150 ARMREST
1 RCE CABLES A3 IN-VALVE OR IN-CAB
2 POWER FLOAT C4 NO ADAPTERS FOR NEW C4 BLOCK
3 150 AUXILIARY B2
4 CANBUS CABLE C2
5 LOW OIL, SPIN. REV. C3 ADAPTERS REQUIRED
SPECIAL FUNCTIONS
1 PRESSURE/TEMP/CHUTE D3 HYDRAULIC MONITORING
2 ROAD TEMP D0 ROAD AND AMBIENT TEMP
3 WIFI D2 NEED EXTENSION?
4 GPS PUCK E0
5 ANTI-ICE E4 USE C4-C4 EXTENSIONS (CUT END)
TOW PLOW
1 TP SPREADER PKG E1 INCLUDES TWO 4-4's
2 MAIN HARNESS D9
3 CANBUS SPLITTER D6
4 SENSOR EXTENSIONS B6 RC ON TRUCK OR TRAILER?
5 SENSOR NETWORK C6 IF PULL-UP RESISTORS REQUIRED
6 VALVE EXTENSIONS E6 RC ON TRUCK OR TRAILER?