8/20
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
5.2 Display, Encoder Box and Joystick
1. Both 550i and 551i displays utilize a ball mount where 4 holes of the flange must be
secured. (See hole array.)
2. A similar ball mount is used when the display is coupled to the armrest – one long arm
and one short.
3. The joystick armrest console utilizes a tube mount that slips over 1-7/8” O/D pedestal
tubing.
4. The tube mount can slide forward and back 1.7” to optimize the armrest position.
(Loosen the ¼-20 nuts.)
5. The ratchet clamp can be used to lock the rotation of the tube and bracket.
6. See the “Installation Notes” for additional recommendations (page 15).
To Next Page
Loading...
