Bosch Rexroth IndraControl L25 - Mounting the EMI shielding; Mounting function modules (optional); Mounting the end clamp

Production failure possible due to con‐
trol failure resulting from a missing EMI
shielding.
NOTICE
Mount the shielding at the right end of the control in order to protect the
control from ESD pulses.
Dangerous contact voltages possible
due to missing EMI shielding.
CAUTION
Mount the shielding at the right end of the control.
Mounting step: Mounting function modules (optional)
1. Thereafter, place the function modules onto the top-hat rail to the left of
the control, if necessary.
2. Slide the function modules along the top-hat rail all the way to the left
side of the control, until a secure connection via the PCI
PLUS
bus is es‐
tablished.
5th mounting step: Mounting the end clamp
1. In order to fix the control correctly on the top-hat rail, finally attach end
clamps to both sides of the Inline station.
1
1
2
① End clamp
② Top-hat rail
Fig.10-15: End clamp
The end clamps are used as lateral termination elements.
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
Bosch Rexroth AG 33/65
Mounting, Dismounting and Electrical Installation