① Release lever
Fig.10-19: Position of the release lever
2. Tilt the control upwards (C in 10-20).
Fig.10-20: Dismounting the control from the top-hat rail
3. Remove the control by pulling it diagonally upwards (C in 10-20).
10.6 Dismounting and changing the Inline terminals
Removing an Inline terminal
1. Remove the labeling field, if present (A1 in 10-21).
Remove all connectors of the terminal. The sections below de‐
scribe how to remove a 2-slot terminal.
2. Pry out the connector of the terminal to be removed by pressing on the
rear connector shaft latch (A2 in 10-21).
Bosch Rexroth AG DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
36/65
Mounting, Dismounting and Electrical Installation
To Next Page
Loading...
