Fig.10-17: Remove the labeling field, removing the connectors
4. Remove the connectors (B in 10-17).
5. Remove the power connector from the control.
This ensures that the feathers of the voltage jumpers and the keyway/
feather key connection are prevented from damage. Moreover, the ter‐
minal can be accessed more easily.
6. Push the release mechanism (1 in 10-18). Then remove the terminal
perpendicularly to the top-hat rail (2 in 10-18).
Fig.10-18: Before dismounting the control, the first Rexroth Inline terminal has to
be removed
Dismounting step: Removing the control from the top-hat rail
1. Loosen the release levers mounted at the bottom side by pulling the re‐
lease lever downwards using a screwdriver.
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
Bosch Rexroth AG 35/65
Mounting, Dismounting and Electrical Installation
To Next Page
Loading...
