6-4 Bosch Rexroth AG | Electric Drives and Controls Rexroth IndraControl VCP 05 | R911299726 / 02
Display and Operating Components
6.2 Keypad
The keys are positioned under an environmental-proof polyester foil.
You project the operating principle of the keys in the programming soft-
ware.
6.2.1 Edit Keys
To activate the edit mode, you must press the data release key at first.
After the status LED „data release“ lights up an input with the edit keys
is possible.
The key 0 and ()° is used for changing data in the editor. The (, ) and °
characters can be entered when configuring the Shift or ShiftCase sys-
tem variables.
The key 1 and STU is used for changing data in the editor. The charac-
ters S, T and U can be entered when configuring the Shift or ShiftCase
system variables.
The key 2 and VWX is used for changing data in the editor. The char-
acters V, W and X can be entered when configuring the Shift or Shift-
Case system variables.
The key 3 and YZ% is used for changing data in the editor. The charac-
ters Y, Z and % can be entered when configuring the Shift or ShiftCase
system variables.
The key 4 and JKL is used for changing data in the editor. The charac-
ters J, K and L can be entered when configuring the Shift or ShiftCase
system variables.
The key 5 and MNO is used for changing data in the editor. The char-
acters M, N and O can be entered when configuring the Shift or Shift-
Case system variables.
The key 6 and PQR is used for changing data in the editor. The charac-
ters P, Q and R can be entered when configuring the Shift or ShiftCase
system variables.
The key 7 and ABC is used for changing data in the editor. The charac-
ters A, B and C can be entered when configuring the Shift or ShiftCase
system variables.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
