R911299726 / 02 | Rexroth IndraControl VCP 05 Electric Drives and Controls | Bosch Rexroth AG 6-5
Display and Operating Components
6.2.2 Navigation Keys
The key 8 and DEF is used for changing data in the editor. The charac-
ters D, E and F can be entered when configuring the Shift or ShiftCase
system variables.
The key 9 and GHI is used for changing data in the editor. The charac-
ters G, H and I can be entered when configuring the Shift or ShiftCase
system variables.
The key Decimal point and :?! is used for changing data in the editor.
The characters :, ? and ! can be entered when configuring the Shift or
ShiftCase system variables.
The key Plus and <=> is used for changing data in the editor. The char-
acters <, = and > can be entered when configuring the Shift or Shift-
Case system variables.
The key Minus and \*/ is used for changing data in the editor. The char-
acters \, * and / can be entered when configuring the Shift or ShiftCase
system variables.
The key Cursor left can be programmed to directly select adjacent
nodes and I/O masks. In the editor it moves the cursor one character to
the left (character selection).
The key Cursor right can be programmed to directly select adjacent
nodes and I/O masks. In the editor it moves the cursor one character to
the right (character selection).
The key Cursor up can be programmed to directly select adjacent
nodes and I/O masks. In the editor it moves the cursor up one variable
(variable selection).
The key Cursor down can be programmed to directly select adjacent
nodes and I/O masks. In the editor it moves the cursor down one vari-
able (variable selection).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
