Bosch Rexroth IndraControl VCP 05 - Function Keys; Slide-In Identification Strips for the Function Keys; Fig. 6-3: Position of the Identification Strip; Fig. 6-4: Identification Strip, Labelled and Blank

R911299726 / 02 | Rexroth IndraControl VCP 05 Electric Drives and Controls | Bosch Rexroth AG 6-7
Display and Operating Components
6.2.4 Function Keys
6.2.4.1 Slide-in Identification Strips for the Function Keys
The slide-in identification strip can be replaced without having to disas-
semble the operator terminal. Inserting the strip on the front side of the
front plate does not influence the specified seal of the operator termi-
nal. A set of identification strips is supplied with the operating device.
For the labeling use:
Fig. 6-3: Position of the identification strip
Fig. 6-4: Identification strip, labelled and blank
The function of the function keys can be freely assigned (with soft key
functions). The function keys can used either as direct keys for menu
control of for triggering a function in the control system.
Single pieces, prototypes Label with a water-resistant pen
Small series Copying foil with laser print
Large series Customer-specific labeled identification
strips
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com