Bosch rexroth SB24 - Assembly, Directional Valve Section and; Assembly, End Plate; End Valve

14/24 Assembly description
BoschRexrothAG, control block SB24/34, RE 66170-10-R/2019-05-15
5.1.4 Assembly, directional valve section and
▶ Orientate the control block segments , with the flange surface ofthe
opposite O-ring side tothe already mounted control block segment and slide
onone after the other via the tie rod screws
... tothe stop.
5.1.5 Assembly, end plate / end valve
1. Orientate the end plate / end valve with the flange surface ofthe opposite
O-ring side tothe already mounted control block segment and slide onvia the tie
rod screws
... tothe stop.
2. Screw the nuts
and/or onto the tie rods ... without using any washers
orlocking washers.