Bosch rexroth SB24 - Tie Rod; Nut

About these products 9/24
RE 66170-10-R/2019-05-15, control block SB24/34, BoschRexrothAG
4.3 Tie rod
▶ Use tie rods (stud screws) according toDIN 835 - M10×length,
propertyclass10.9.
Oneach shaft end
and , the tie rod isprovided with athread for different use.
• Interference thread
with 20mm length (thread undercut + thread), which
isscrewed into the AP.
• Nut thread
The required tie rod length depends onthe number and combination ofthe control
block segments.
The tie rod length L isdetermined asfollows: L =
+ +
The determination process for the required tie rod length isexactly described
indatasheet66170.
NOTICE! The tie rods must not bedeformed duringassembly/disassembly ofthe
control block segments!
4.4 Nut
For the tie rod nut thread , different nuts are used, depending onthe final control
block segment (AP orCVL and/or EP orEVL).
▲ DIN 970–M10 for connecting (AP) and end
plate (EP)
▲ Shoulder nut M10 for connection valve
(CVL) and end valve (EVL)