18/36 Commissioning
Bosch Rexroth AG, Valve amplifier VT-MSPA, RE 30232-B/08.2020
7.5.4 Suppressing interference of the system
Should interference occur in conjunction with signals of the electronics, inspect the
interference suppression of other electrical components, e.g. as follows:
Possible causes of faults
Switched inductance DC: anti-parallel free-wheeling diode across actuator winding
AC: type-related R/C combination over actuator winding.
Electric motors R/C combination from each motor winding to earth.
Frequency converter Inlet filter in the voltage supply of the frequency converter
Motor control lines shielded and installed separately from other
cables and/or output filter for motor cables.
Extensive contact of the frequency converter housing to the rear
wall of the control cabinet
8 Commissioning
NOTICE
Uncontrolled plugging and unplugging of connectors!
The device might be destroyed.
▶ Before plugging or unplugging connectors into or from the device, disconnect
the device from the power supply or de-energize it reliably!
Damage to the device caused by incorrect handling is not covered by the
warranty!
▶ Observe the protection class, the voltage supply and the environmental
conditions according to data sheet RE 30232.
For commissioning we recommend using a multimeter.
To Next Page
Loading...
