Installation (only for approved contractors)
21
Tronic 5000 – 6721830067 (2021/06)
5.9 The air must be purged from the appliance
After all of the hydraulic connections to the appliance have
been carried out, purge the air from the appliance,
▶ Turn on the cold water supply.
▶ Turn on a hot water tap for 1 minute to purge air from the
appliance.
Fig. 36
[1] Hot water tap
5.10 Appliance configuration
CAUTION
Risk of electric shock!
Before configuring the appliance,
▶ Turn off the electric supply at the electrical cabinet.
It is possible to configure several parameters on the same
appliance.
▶ Use the electronic Jumpers provided to carry out the
different appliance configurations.
Fig. 37 Supplied electronic Jumpers
▶ Save the removed Jumpers for future changes or
installations.
Fig. 38
To Next Page
Loading...
