EC
Connecting
the
Acoustimass®
module
to
the
media
center
Connect the Acoustimass module
to
the media center with the audio input cable (Figure 10).
)
N@'I;@):
Be sure that each connector is fully inserted into each jack.
1.
Plug the small black multi-pin connector (flat side facing up) into the SPEAKER ZONES
jack labeled
"1"
on the
back
of
the media center.
2.
Insert the
te~ephone-style
RJ-45 connector on the other end
of
the
audio input cable into
the AUDIO INPUT
jack
on the Acoustimass module. When properly connected, it should
lock in place.
)
N@'I;e:
Refer
to
"Setting up a second listening zone" on
page
25
for information on connecting
a second zone.
Acoustimass connection to
media center
N@'I;e:
Press tab
to
release cable connector.
When
fully inserted into the jack, the connector
locks
in
place.
A CAUTHON: Do
not
place strain on the audio input cable, especially on the connection
to
the
Acoustimass module. Placing excessive strain on the cable may cause damage
to
the cable
connection
at
the Acoustimass module.
When
disconnecting the cable from the Acoustimass
module,
be
sure to press the tab on the connector.
13
To Next Page
Loading...
