The TV on/off detector senses whether your TV is on or off. This enables th
au~~ma~i~ally switch the T!f on, as needed, when another video source
(D
box, etc.) is selected. If you choose no% to 1~se the sensor, you will need to turn the TV an s@p-
arately each time it is needed.
.”
This device will not work with LCD and plasma TVs, so you may want to skip these
steps.
1. Plug the ~~nne~~or on the end of the cord into the TV ~~~~~~ jack on the back of the
media center.
2. Position the 4v on/off detector on the back of your TV as shown in Figure 16.
.*
DO NOT use the mounting strip yet to affix the detector Wait until your system is oper-
and you can determine that the sensor is working properly from this location. Refer to
“Testing the TV on/off detector” in your L.lFESTYLP Operating Guide.
TU on/off defecfor insfalled
on your 7V
Mounting the detector
sing the mounling strip
a center rear panel
If you have a projection TK the bottom rear of the enclosure is the best location for
mounting the detectot:
When you listen to TV sound through your ~1~~~~~~~ system, the speakers in your TV
should not be on. Use the on-screen menus in your TV to select ““internal ~~~a~er~~ Off” (your
on-screen message may be different). Y’ou can ~ISO lower the volume of your TV to its lowest
setting. Refer to your TV owner’s guide for detailed instructions.
Installing
the
TV
on/off
detector
(optional)
The TV on/off detector senses whether your
TV
is on
or
off. This enables the media center
to
automatically switch the
TV
on, as needed, when another video source
(DVD,
cable/satellite
box, etc.) is selected. If you choose not to use the sensor, you will need to turn the
TV
on sep-
arately each time it is needed.
) N@te: This device will not work with LCD
and
plasma
TVs,
so you may want to skip these
steps.
1. Plug the connector on the end
of
the cord into the TV SENSOR jack on the back
of
the
media center.
2.
Position the TV on/off detector on the back
of
your
TV
as shown
in
Figure 16.
) N@te:
00
NOT use the mounting strip
yet
to affix the detector.
Wait
until your system is
oper
ating
and
you can determine that the sensor is working properly from this location. Refer to
'Testing the
TV
on/off detector"
in
your LIFESTYLe" Operating Guide.
Mounting the detector
using the mounting strip
Back
afTV
TV SENSOR
jack
) N@te:
If
you have a projection
TV,
the bottom rear
of
the enclosure is the best location for
mounting the detector.
TV
on/off
detector instaffed
on
your
TV
Turning
off
the
internal
speakers
in
your
TV
When you listen
to
TV
sound through your
L1FESTYLE®
system, the speakers
in
your
TV
should not be on. Use the on-screen menus
in
your TV to select "Internal Speakers: Off" (your
on-screen message may be different).
You
can also lower the volume
of
your
TV
to
its lowest
setting. Refer
to
your
TV
owner's guide for detailed instructions.
18
To Next Page
Loading...
