Connecting
your
cable/satellite
box
to
the
system
(optional)
The type
of
video connection used with your
TV
and VCR must match the type
of
connection
used with your cable/satellite box, if you choose
to
connect it
to
the system. If you connected
your
TV
to
the COMPOSITE VIDEO OUTPUT, connect your cable/satellite box output
to
the
COMPOSITE VIDEO
INPUT.
If you connected your TV to the S-VIDEO OUTPUT, connect your
cable/satellite box
to
the S-VIDEO
INPUT.
J N@te:
If
your cable/satellite box
did
not come with the stereo audio
and
video cables required
to
connect it
to
your
LIFESTYLE!"
system, contactyour local electronics store
or
authorized
Bose dealer.
The rear panel
of
the media center provides audio and video connections for your cable/sat-
ellite box.
1.
Using a stereo audio cable, connect the left
(L)
and right
(R)
audio outputs (if available) on
the rear panel
of
your cable/satellite box
to
the
Land
RAUX
audio inputs on the rear
panel
of
the media center.
J N@te: For convenience, until your system
is
completely installed
and
tested, you
may
want
to
postpone making this connection
to
the media center
AUX
jacks.
The
AUXjacks are required
for use with
a temporary headset connection during the final installation steps.
2.
Using a video cable, connect the VIDEO OUT on the rear panel
of
your cable/satellite box
to the COMPOSITE video input on the rear panel
of
your VCR. If your VCR is already con-
nected there, you may instead connect the VIDEO OUT from your cable/satellite box
directly
to
your media center's COMPOSITE video input
(as
shown in Figure 15).
Media center-to-cablelsat-
ellite
box
video
and
audio
connections (if
VCR
not
used)
Cable/satellite box
IS
~I
17
To Next Page
Loading...
