Making
the
temporary
headset
connection
before
connecting
to
power
Plug the special headset connector into the AUX jacks on the rear of the media center (Figure
17).
This is for temporary use during steps for "Finishing the installation" on page 21.
Headset connection for use
in the final setup steps
Figure
17
Connecting
the
system
to
power
Connect the two AC power (mains) cords
in
the following order:
1.
Plug the small end
of
the Acoustimass® module power cord into the AC power jack on the
connector panel
of
the Acoustimass module (Figure
18).
Plug the other end
of
the power
cord into an AC (mains)
outlet
2.
Turn the Acoustimass module POWER switch
to
on ( I
).
Figure
18
Power connection
of
the
Acoustimass moduler
......
Connector panel
Power switch
19
To Next Page
Loading...
