Bose PowerShare PS404A - AmpLink Test Setup

86
TEST PROCEDURE
Important Note: All measurements for power amp require a AUX-0025 Digital Filter (or equivalent) with
a 20Hz-20kHz lter in order to get the correct output noise and level readings.
AmpLink Test Setup
1. Open the ControlSpace Designer software. Congure the ESP-880 (or similar) as an AmpLink signal
source. Refer to the diagram below.
ESP-880 in ControlSpace Designer window - Open CSD and double-click to view.
2. Set up the Device Under Test (DUT is Summit-A) as shown in the below diagram.