42
TEST PROCEDURE
7. Button Extended Functions Test
7.1 Perform the button tests below to verify extended functionality of the buttons/control.
Product I/O User
control
Trigger User action
Power
button
Short press the power button
when system is o/on
Power LED on and system power on/
o.
Press and hold the button for
10 sec
“Resetting the system” appears on
the channel displays then all the set-
tings will be set to default and reboot
the system.
BT button
Press and hold the BT but-
ton for 2 seconds
BT LED will blink in 2Hz (0.5 sec on
and 0.5 sec o). Start the BT pairing/
Disconnect any BT connection.
Press and Hold 10 seconds
Bluetooth factory reset and clear all
current devices.
Channel
1 or 2
Channel
controls
button
Rotate the channel control
Singal/Clip LED will be ON if insert-
ing. Volume adjust.
Press and Hold the Channel
1 or 2 Channel controls 10
seconds
Additional controls menu appears on
the channel display.
Press the channel control Select appropriate item.
Rotate the channel control Highlight the appropriate preset.
Press the channel control To select the item.
Press and Hold the Channel
1 or 2 Channel controls
Additional controls menu disappears
on the channel display.
Channel 3
Channel
controls
button
Rotate the channel control
Singal/Clip LED will be ON. Volume
adjust.
Press and Hold the Chan-
nel 3 Channel controls 10
seconds
Additional controls menu appears on
the channel display.
Press the channel control Select appropriate item.
Rotate the channel control Highlight the appropriate preset.
Press the channel control To select the item.
Press and Hold the Channel
3 Channel controls
Additional controls menu disappears
on the channel display.
7.2 Before returning the system to the customer, Factory Default the system by pressing and holding
the Power Button for 10 seconds.