Bose Wave music system Supplementary Guide

4
BRACKET INSTALLATION
EnglishEspañolItaliano DeutschFrançaisNederlandsKorean ThaiArabic S. Chin
Before using your drill
Before you begin to drill, center the tip of the drill bit in each drill
hole circle you draw.
WARNING:
Use eye protection and be sure to
observe all safety
precautions while using a drill or
cutting tool.
WARNING:
Make sure the spot chosen is safe for
cutting. Do not cut through surfaces that may have
hazards such as electrical wiring, conduits, or plumb-
ing concealed behind them. Follow all other safety
precautions.
Deciding where to mount the bracket
Before you assemble the bracket by attaching the platform to the mounting assembly, !
decide which type of mounting you prefer. Choose wall mounting to allow for the height
required by a Wave
®
music system on a Multi-CD Changer or a Wave
®
radio/CD. These !
products do not fit in an under-cabinet installation.
Also consider:
• Convenience.
• Distance to an electrical outlet.
• Appearance of your Wave
®
system in this location (Figure 3).
• Access to system features, like the CD player, as needed.
Figure 3
Bracket used for a) under-
cabinet or b) wall mounting
a
)
b)
Under-cabinet
mounting
Wall
mounting
For under-cabinet mounting, follow
instructions for “Under-cabinet
installation” on page 5.
For wall mounting, follow
instructions for “Mounting
the bracket on a wall” on
page 7.

Bose Wave music system Specifications

General

Sound output mode	Stereo
Radio tuner	AM/FM
Clock	Yes
Headphone Jack	Yes
Media type	CD