Various Settings
14
Preserving/Muting the Tail of an Effect when the Effect is Switched Off
(CARRYOVER)
This sets whether to preserve (carry over) the tail of an effect after the effect is switched off.
1.
Press and hold down the [TAP] switch, and turn on the power.
2.
Turn the Mode knob to the “MULTI-HEAD” setting.
3.
Use the [MEMORY] button to select the setting.
Reverberation carries over
Reverberation does not carry over
4.
Press the [TAP] switch to exit the settings.
This is only supported when the effect is turned on/off. This is not supported when switching between memories.
● If this function is set to carry over the effect, the self-oscillation of the effect continues to be output, even if the effect
is turned off while the effect sound is self-oscillating. To stop the self-oscillating sound, turn the [INTENSITY] knob all
To Next Page
Loading...
