19
Expression Pedal Hold is particularly useful when the expression pedal
is assigned to a volume function, such as foot volume or patch volume.
This eliminates volume jumps when switching between patches.
Press SYSTEM.1
Turn the dial to select PLAY OPTION, and then press ENTER.2
Use the 3 5 and 6 buttons to select the “Exp Pdl Hold” line.
Turn the dial to choose the desired setting: On or Off.4
Press EXIT twice to return to the Play screen. 5
At the GT-10’s factory default setting, the Expression Pedal Hold switch
is turned on.
Display Modes and Realtime Control Assignments
At the top of this booklet, and at various times throughout, we’ve talked a
bit about the GT-10’s different display modes. After you’ve made some of
your own control assignments—or if you just want to quickly see what’s
assigned in any patch—the following screen variations can help you quickly
see what’s assigned.
Play Screen
To select these variations, press the DISPLAY MODE button while the Play
screen is displayed.
Play Screen 4 Play Screen 5
SW&PDL FUNCTION Screen
To toggle between these two variations, press the DISPLAY MODE button
while the SW&PDL FUNCTION screen is displayed.
ASSIGN Screens
To toggle between these two variations, press the DISPLAY MODE button
while any ASSIGN screen is displayed.
The End
We hope you’ve found this workshop helpful. Keep an eye out for new
GT-10 updates and support documents, available as free downloads at
www.BOSSUS.com and www.RolandUS.com.
To Previous Page
Loading...
Need help?
General
