7
P02-3: IRISH DELAY
This patch combines two vintage British
combo amps with a timed delay effect,
creating a sound first popularized by UK
bands in the ‘80s.
Effects used in this patch:
PREAMP (Channels A and B)
• CHORUS•
DELAY• REVERB•
PEDAL FX (FOOT VOLUME/WAH)•
When this patch is selected, PREAMP A and B (both channels), CHORUS,
REVERB, and PEDAL FX (FOOT VOLUME) are on. Use the onboard realtime
controllers as follows:
CTL 1—
• This switch is assigned to BPM Tap, allowing you to set the speed
of the GT-10’s master BPM (beats per minute) rate by “tapping” in time
on the foot switch. The delay effect is assigned to follow the master BPM
with a dotted eighth-note delay time, creating a cool rhythmic effect.
When CTL 1 or CTL 2 are set to control BPM Tap, the switch’s LED
flashes in time with the master BPM rate.
CTL 2—• When this foot switch is pressed, DELAY is toggled on and off.
EXP PEDAL SW ON/OFF—
• When this switch is pressed, the expression
pedal function toggles between controlling FOOT VOLUME and WAH.
Expression pedal—
• Controls FOOT VOLUME or WAH, depending on the
EXP PEDAL SW ON/OFF setting.
P03-4: ROTARY CONTROL
Here, we have a classic British stack-type
amp combined with a rotary speaker effect.
Effects used in this patch:
PREAMP (Channels A and B)
• EQ•
FX-1 (TONE MODIFY)• FX-2 (ROTARY)•
PEDAL FX (FOOT VOLUME/PEDAL BEND)•
When this patch is called up, PREAMP A, EQ, FX-1, FX-2, and PEDAL FX (FOOT
VOLUME) are on. Use the realtime controllers as follows:
CTL 1—
• When this foot switch is pressed, PREAMP toggles between
Channel A to Channel B.
CTL 2—
• When this foot switch is pressed, the speed of the ROTARY effect
toggles between FAST and SLOW.
The GT-10’s ROTARY effect emulates the sound of a vintage “rotating
speaker” cabinet. When the speed control is toggled, the speed change
is gradual, just as it is when adjusting the motor speed on an actual
rotating speaker cabinet.
EXP PEDAL SW ON/OFF—• When this switch is pressed, the expression
pedal function toggles between controlling FOOT VOLUME and PEDAL
BEND.
Expression pedal—
• Controls FOOT VOLUME or PEDAL BEND, depending
on the EXP PEDAL SW ON/OFF setting.
P12-4: LEAD+CTL FLANGE
This patch combines a classic British stack-
type amp with modulation, delay, and
reverb effects.
Effects used in this patch:
PREAMP (Channels A)
• DELAY•
FX-1 (PHASER)• FX-2 (FLANGER)•
REVERB (Room)• PEDAL FX (FOOT VOLUME/WAH)•
When the patch is selected, PREAMP B, DELAY, REVERB, and PEDAL FX (FOOT
VOLUME) are on. Use the realtime controllers as follows:
CTL 1—
• When this foot switch is pressed, FX-1 toggles on/off.
CTL 2—
• Here, this foot switch is set to the “momentary” setting. When
CTL 2 is pressed, FX-2 turns on. When the switch is released, FX-2 turns
off again.
To Next Page
Loading...
Need help?
General
