Settings for Each Track
18
Parameter Value Explanation
Track1:Rec Level
100
Adjusting the recording level of the Tracks ( Recording Level)
You can adjust the recording level of the tracks.
0–200
If you set the recording level at 100 (default value), the volume of the performance and that
of the recording will be identical.
If you set the recording level to a value lower than 100, the volume of the recording will be
lower than that of the performance. As a result, the sound of the performance won’t get
buried by the recorded sound, even if you record a multiple number of times.
Track1: Pan
CENTER
Adjusting the Positioning of the Track’s Sound (Pan)
You can adjust the positioning (panning) of the track’s sound.
L50–CENTER–R50
With the “CENTER” setting, the sound will be heard from the center.
“L” settings position the sound toward the left, and “R” settings position the sound toward
the right. With a setting of L50, the sound will be heard only from the left.
Track1: Loop Sync
ON
Aligning the Beginning of Loop Playback (Loop Sync)
If you turn Loop Sync on for two or more tracks, loop playback of those tracks will be synchronized at the beginning
of the longest phrase with Tempo Sync on among these tracks.
Loop Sync: ON
Loop Sync: ON
Loop Sync: OFF
Track 1
Track 2
Track 3
Play repeatedly, starting in synchronization with the
beginning of the longest phrase.
For tracks whose Loop Sync is off , playback
will repeat at the length of the phrase.
Playback starting location
If you turn Loop Sync on, the beginning of the tracks will always be aligned. This means that if tracks are already
playing back, the playback start location of the other tracks will become “the current location of the phrase being
played.” The following illustration is an example of how playback will occur with three tracks that contain the
identical melody but have di erent loop sync settings.
Loop Sync: ON
Loop Sync: ON
Loop Sync: OFF
Track 1
Track 2
Track 3
For a track with Loop Sync on, playback starts midway
through the phrase (from the current location).
For a track with Loop Sync off , playback
always starts at the beginning of the phrase.
OFF Playback will loop at the length of the phrase.
ON
Playback will loop in synchronization with the start of the longest phrase of the tracks for
which Loop Sync is turned on.
Track1: TempoSync
ON
Synchronizing the Tempo (Tempo Sync)
Each track saves the tempo at which that track was recorded. This is called the “original tempo” of the track. The
phrase memory also has a “phrase memory tempo” that is shared by all tracks 1, 2, and 3.
Normally, you should leave Tempo Sync on, so all tracks will play at the same tempo (the phrase memory tempo).
If you turn Tempo Sync o for tracks for which you don’t want the tempo to change (such as those with special
e ects), you’ll be able to obtain playback that is always at the original tempo (track 3 in the illustration below).
Tempo Sync: ON
Tempo Sync: ON
Tempo Sync: OFF
Playback Tempo: 120
Playback Tempo: 120
Playback Tempo: 80
Track 1
Track 2
Track 3
Tracks for which Tempo Sync is on will play at the phrase memory tempo.
Tracks for which Tempo
Sync is off will play at the
original tempo.
Phrase Memory Tempo: 120
Original Tempo: 140
Original Tempo: 100
Original Tempo: 80
OFF The track will play at its own original tempo.
ON The track will play at the phrase memory tempo.
To Next Page
Loading...
Need help?
General
