Bostitch BCN662 - Depth Adjustment Precautions; Headlight Functionality; Low Battery and Jam Indicators; Jammed Nail Clearing Steps

ENGLISH
11

WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove batterypack.
• Engage trigger lock-off.
• Avoid contact with trigger duringadjustments.
1. To drive the nail shallower
, rotate the depth
adjustment wheel
3
away from the nose of thenailer.
2. To sink a nail deeper
, rotate the depth adjustment
wheel
3
toward the nose of thenailer.
Fig. J
3
13
Headlights (Fig. K)
There is a headlight
4
located on each side of the nailer.
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
inuse.
Fig. K
4
NOTE: These headlights are for lighting the immediate work
surface and are not intended to be used asflashlights.
LOW BATTERY INDICATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
lowbattery.
JAMMED NAIL INDICATOR: The right-side headlight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Clearing a Jammed Nail (Fig. A, L)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
toclear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Press the pusher
16
and remove any loadednails.
3. Lift the jam clear latch
5
then pull up to open the
nosepiecedoor.
4. Remove bent nail, using pliers ifnecessary.
5. If driver blade is in the down position, cycle the stall
release lever
12
using enough force to fully slide it to
the other end of the slot in thehousings.
6. Close the nosepiece door and engage the latch pin
under the two arms on the nosepiece. Push latch until
it locks inplace.
7. Reinsert batterypack.
NOTE: The tool will disable itself and not reset until the
battery pack has been removed andreinserted.
8. Reinsert nails into magazine (see Loading the Tool).
Fig. L
5
12
NOTE: Should nails continue to jam frequently in
nosepiece, have tool serviced by an authorized BOSTITCH
servicecenter.
Cold Weather Operation
When operating tools at temperatures below freezing:
1. Keep tool as warm as possible prior touse.
2. Actuate the tool 5 or 6 times into scrap lumber
beforeusing.
Hot Weather Operation
Tool should operate normally. However, keep tool out of
direct sunlight as excessive heat can deteriorate bumpers
and other rubber parts resulting in increasedmaintenance.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/