To Next PageTo Next Page
Need help?Do you have a question about the Bostitch F28WW and is the answer not in the manual?
General| Type | Framing Nailer |
|---|---|
| Magazine Angle | 28 Degrees |
| Tool-Free Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| Sequential Trip Trigger | Yes |
| Nail Length Range | 2 inches to 3-1/2 inches |
| Nail Diameter Range | 0.113 inches to 0.131 inches |
| Operating Pressure | 80 to 120 PSI |
| Fastener Type | Wire Weld Collated |
Provides essential safety precautions and requirements for using the tool.
Details requirements for air supply, fittings, hoses, and regulators.
Instructions on how to safely load fasteners into the tool.
General guidelines for operating the pneumatic tool safely.
Covers essential maintenance procedures for the pneumatic tool.
Lists models, actuation types, dimensions, and weights of the F series tools.
Details the types and sizes of fasteners compatible with each tool model.
Specifies the air fitting type and internal diameter required for the tool.
Recommends the optimal operating pressure range for fastener performance.
Provides information on the air volume required for tool operation.
Explains the two available operation modes: Sequential Trip and Contact Trip.
Refers to operation instructions for identifying tool models.
Details requirements for air supply, filters, and regulators.
Advises on pressure limits to prevent increased tool wear.
Explains the role of air filters in maintaining tool performance.
Provides guidance on proper lubrication for optimal tool performance.
Offers advice for operating the tool in cold weather conditions.
Step-by-step instructions for loading fasteners into F series tools.
Instructions for installing and removing the guide rod on specific models.
Explains how to adjust the nail drive depth using the contact arm.
Describes how to adjust the exhaust deflector's position.
Procedure for safely removing jammed or loaded nails.
Essential steps before operating the tool, including reading the manual.
Details the operation of the sequential trip trigger for driving fasteners.
Details the operation of the contact trip trigger for rapid nailing.
Explains using the sequential trip with the metal connector attachment.
Step-by-step checks to ensure correct tool operation and safety.
Key practices for safe tool usage beyond standard warnings.
Covers maintenance, caution with springs, and replacement parts.
Instructions for assembling seals with proper lubrication.
Discusses the importance of adequate air supply for tool performance.
