To Next PageTo Next Page
Need help?Do you have a question about the Bostitch N50FN and is the answer not in the manual?
General| Operating Pressure | 70-120 PSI |
|---|---|
| Power Source | Pneumatic |
| Depth Adjustment | Yes |
| No-Mar Tip | Yes |
| Type | Finish Nailer |
| Nail Size/Fastener Length | 1-1/4 in to 2 in |
| Magazine Capacity | 100 |
| Magazine Angle | 15 degree |
Mandates ANSI-compliant eye protection against flying particles.
Covers hearing/head protection, air supply, loading, and general operation safety.
Prohibits improper gases and exceeding pressure limits to prevent tool damage.
Details tool models, fasteners, air fitting requirements, and operating pressure.
Explains operation modes: Trigger, Contact Trip (single/rapid), and Sequential Trip.
Specifies requirements for fittings, hoses, regulator, and filter maintenance.
Outlines proper lubrication, recommended lubricants, and cold weather operations.
Step-by-step guide for inserting nails, engaging pusher, and changing lengths.
Describes how to adjust the exhaust deflector for desired airflow direction.
Explains single fastener drive per trigger pull.
Details single fastener placement and rapid fastener operation methods.
Describes sequence of contact trip then trigger pull for fastener driving.
Procedures to verify correct operation of Trigger, Contact Trip, and Sequential Trip modes.
Lists essential rules for safe and appropriate use of the pneumatic tool.
Covers pusher spring caution, replacement parts, seals, and lubrication.
Discusses impact of air volume, pressure, and system restrictions on tool performance.
Lists common issues like leaks, failure to cycle, or skipping fasteners with their causes and corrections.
Steps to adjust fastener drive depth using the dial and setting air pressure.
Explains the quick release door for easy access to clear jammed fasteners.
Lists available lubricants, kits, tool components, and adhesives for maintenance.
