To Next PageTo Next Page
Need help?Do you have a question about the Bostitch T50 and is the answer not in the manual?
General| Material | Metal |
|---|---|
| Staple Size | 1/4 - 9/16 in |
| Usage | Upholstery |
| Staple Gauge | 20 ga |
| Staple Leg Length | 1/4 inch to 9/16 inch |
Identifies the specific tool model covered in the manual.
Provides crucial initial safety notices before tool operation.
Describes the T50 series staplers and the importance of manual instructions.
Outlines the manufacturer's warranty terms and conditions.
Emphasizes the mandatory use of ANSI-compliant eye protection and other safety gear.
Warns about hazards related to air supply sources and connections.
Provides safety guidelines for loading and operating the tool.
Advises caution and adherence to warnings during tool maintenance.
Lists detailed specifications for T50 models and compatible fasteners.
Specifies air fitting requirements, operating pressure, and air consumption.
Describes Trigger, Contact Trip, and Sequential Trip operation methods.
Details air supply, fittings, hoses, regulator, and filter for safe operation.
Explains lubrication requirements, types, and cold weather considerations.
Provides a step-by-step guide on how to load staples into the tool.
Details steps for adjusting the Dial-A-Depth™ for desired fastener depth.
Recommends using only specified Bostitch staples for the T50 Series.
Explains the operation of the trigger-only model.
Details single fastener placement and rapid operation modes.
Explains the sequential trip mechanism for controlled driving.
Outlines procedures to verify correct operation of all tool modes.
Provides additional important safety guidelines for operating the tool.
Covers maintenance safety warnings and replacement parts recommendation.
Provides seal assembly instructions and discusses air supply impact on maintenance.
Addresses common air leaks from the trigger valve, stem, and frame.
Guides on resolving issues with tool failure to cycle or lack of power.
Provides solutions for skipping fasteners, intermittent feed, and jams.
Explains the quick release door feature and its operation.
Instructions on how to adjust the directional exhaust deflector.
Lists available accessories for the Bostitch T50 series staplers.
