MRI Mode
Verciseā¢ DBS Remote Control 4 Directions for Use
92378769-02 37 of 1157
Charge Stimulator Now Screen (Rechargeable Stimulators Only)
The Stimulator battery must be fully charged before MRI Mode is enabled. If the Stimulator battery is not
fully charged, the Remote Control will display one of the following messages instructing the patient to
charge the Stimulator before enabling MRI Mode.
Warning: Always check the Stimulator battery to ensure that it is fully charged before performing a
scan on the patient.
1. Press
to dismiss the error message and return to the Remote Control Home screen.
2. Instruct the patient to charge the Stimulator.
3. Enable MRI Mode once the Stimulator is fully charged.
To Next Page
Loading...
