10 [MODE SELECT/REC SPEED]
Use [Mode Select] to select between these three modes:
n CHNS〈 〉SCENES
n
A DOUBLE PRESET B
n
1-12 SINGLE PRESET
Use [Rec Speed] to adjust the speed of all programmes in ‘Mix’ mode.
11 [UP/CHASE REV]
Use [DOWN] to change a scene in Edit mode.
Use [CHASE REV] to change the direction of all chases.
12 [PAGE]
Switches between the four PAGES (banks).
13 [DELETE/REV ONE]
[DELETE] deletes every step of a scene.
[REV ONE] changes the direction of a chase.
14 [Display]
This display shows the current activity or programme status.
15 [INSERT/% OR 255]
Use [INSERT] to add steps to a scene.
Use [ % OR 255] to choose whether to see the value as a percentage value or as a value between 0-255.
16 [EDIT/ALL REV]
[EDIT] is used to start the Edit mode.
Use [ALL REV] to change the direction of all programmes.
17 [ADD OR KILL/REC EXIT]
In [ADD] , several Scenes or Flash buttons are active.
In [KILL] , pressing a flash button disables any other scene or programme.
Use [ REC EXIT] to quit the Edit mode.
18 [RECORD/SHIFT]
[RECORD] is used to start the Record mode or to programme a Stop.
[SHIFT] is only used in conjunction with other buttons.
19 [MASTER A]
Sets the intensity of Master A to 100 % as long as the button is pressed.
20 [PARK]
In CHNS
〈
〉
SCENES mode, you can switch between single-chase or mix-chase mode.
In Single-chase mode, the activated programmes run one after the other. In Mix-chase mode, the activated pro-
grammes run simultaneously.
Connections and controls
DMX DC-1224
13
DMX controller
To Next Page
Loading...