22
①12V system voltage: 5-11V, 5V(default)
②24V system voltage: 10-22V,
10V(default)
Note:
①Light control on: The solar panel
voltage is less than the adjusting
voltage.
② If it is the system of 24V, relevant
voltage points shall be automatically
multiplied by 2.
Setting method: Same as above.
Menu 15: Light control voltage(mode 1)
16 9
81
Adjust voltage range: 0-960s, step 60s.
Default：60s.
Note: Minimum duration required to meet
the light control on or off condition.
Setting method: Same as above.
Menu 16: Light control delay(mode 1)
16 9
81
E00: The system is working normally.
Note: It can only be viewed, and it shows
that the E00 system is working normally,
and other error codes need to be checked.
Setting method: Same as above.
Menu 17: Error code(mode 1, mode 2, mode 3)
16 9
81
To Next Page
Loading...
Need help?
General
