CONNECTING TO A BALANCED INPUT AMPLIFIER
With your 2010 Preamplifier’s balanced outputs driving a balanced
input power amplifier, you can take sonic advantage of short speaker
cables and correspondingly longer input cables. With the 2010’s
low output impedance, distances of more than 50 meters between
preamplifier and power amplifier are practical.
Connect each amplifier input to the main outputs labeled “MAIN
OUT 1” or ”MAIN OUT 2.” If it is desired to use three or more amplifiers
such as in tri-amping, splitters will be required. If in doubt, consult your
Boulder dealer.
GETTING
STARTED
1-7
To Next Page
Loading...
