4-11
RESTORE TO FACTORY DEFAULTS
Should you wish to have all settings reset to original factory defaults,
you may execute a master reset. Normally, this function is not used.
From “PROGRAM MODE” press the POWER pushbutton. “RESET
ALL?” will show in the left display and “1=YES 2=NO” will show in the
right display.
To leave all settings as they currently are, press the TWO
pushbutton.
To reset all settings, press the ONE pushbutton.
All other pushbuttons are inoperative during this time. The 2010
Preamplifier will then return to normal operating mode.
WARNING: All settings which you have programmed in will be lost,
including the names of each input.
PROGRAMMING
To Next Page
Loading...
