Bowflex Revolution - Maintenance

8
Unboxing Your Bowflex Revolution
®
Home Gym
Step 3
Parts:
• Rear Stabilizer (Box 2)
Tools:
• 5/16” Allen Wrench
• 7/32” Allen Wrench
• 3/4” Wrench or Adjustable Wrench
3-1 Place the Rear Stabilizer in the bracket on the
Main Frame with the feet pointing away from the
frame Make sure the two bolt holes in the Rear
Stabilizer are pointing downward.
Hardware (1:1):
2 Allen Bolt (1/2” X 3 1/4”)
4 Washer (1/2”)
2 Washer (3/8”)
2 Nylock Nut (1/2”)
2 Allen Bolt (3/8” X 3/4”)
3-2 Install but do not tighten two 3/8”x 3/4” Allen Bolts
and 3/8” washers in the underside of the Rear
Stabilizer.
3-3 Install two 1/2”x3 1/4” Allen Bolts with 1/2” washers
and Nylock Nuts in the sides of the Rear Stabilizer.
3-4 Completely tighten all of the hardware.
3-5 Slide the Foot Caps onto the feet of the Rear
Stabilizer.
Main Frame
Rear Stabilizer
Bracket
Feet point away
from frame
Threaded bolt holes
point downward
1/2”x 3 1/4” Allen Bolt
1/2” Washer
1/2” Washer
1/2” Nylock Nut
3/8” Washer
3/8”x 1/4” Allen Bolt
Foot Cap