Pre Start Inspection and Operation
3.3
Do the following pre-start service checks:
1. Check condition of all warning and instructional decals. Replace any damaged decals with
genuine Boxer decals.
2. Check engine oil:
• Make sure that the engine is OFF.
• Pull out the engine dipstick (Item 1, Figure 3–1) and check oil level. The correct level is
between those two lines.
Figure3-1 Engine Oil Level Check
• If the engine oil level is below the bottom line, carefully add the proper amount of oil
through the engine oil ller until the level is even with the top line (Item 1, Figure 3–2). To
reach the oil ller cap, remove the lower locking service panel. It is important to add the
correct type of engine oil as stated in the engine manual.
NOTE: Make sure to reinstall and secure the oil ller cap.
To Next Page
Loading...
