BOXER 322D - New Machine Brake-in Maintenance Procedures

Routine Service and Maintenance
4.13
New Machine Brake-in Maintenance Procedures
Do the following after the rst 20 operating hours for a new machine only.
1. Change engine oil - Refer to the engine manual for the proper engine oil changing
instructions..
2. Change engine oil lter, which is located on the left side of the engine - Refer to the engine
manual for the proper engine oil lter changing instructions and (Item 1, Figure 4–14).
Figure 4-14Engine Oil Filter
3. Change the hydraulic lter. See Service Manual and Figure 4–15.
• The hydraulic lter will be lled with hydraulic uid. Make sure to dispose of
the used hydraulic lter in an appropriate manner and according to State and
Local regulations.
• Make sure to dispose of the used hydraulic uid in an appropriate manner and
according to State and Local regulations.
• Place a container under the hydraulic lter assembly to capture any hydraulic
uid that may drain out.
a. Remove the spin-on hydraulic lter (Item 1, Figure 4–15) from the lter mount that is
located underneath the hydraulic cooler.
• To access the lter assembly, reach in through the access opening under the fuel tank.
• Make sure to allow the engine and hydraulic system to cool o before beginning this
procedure.
1
CAUTION
NOTICE