Troubleshooting
2
Problem Possible Causes Corrective Action
Engine will not start, starts
hard, or fails to keep run-
ning.
• Auxiliary hydraulics/ Operator
presence lever is either in
Forward or Reverse position
with no hydraulically powered
attachment installed.
• Move lever to neutral
position.
• Fuel tank is empty. • Fill fuel tank with fuel.
• Air cleaner is dirty. • Clean air lter housing and
replace the lter elements.
• Bleed air from fuel system
• Fuel injector dirty or fouled. • Contact Authorized Service
Dealer.
• Dirty or contaminated fuel lter. • Replace fuel lter.
• Dirt, water, or stale fuel is in
fuel system.
• Drain fuel in tank into
an appropriate storage
container and dispose of bad
fuel properly.
• Rell fuel tank with fresh,
clean fuel.
• Empty fuel/water separator
bowl.
• Replace fuel lter.
• 15 Amp fuse blown. • Replace fuse.
Engine looses power.
• Engine load is excessive • Reduce ground speed.
• Reduce speed of
attachment.
• Air cleaner is dirty. • Clean air lter housing and
replace the lter elements.
• Engine oil level in crankcase
is low.
• Add the appropriate engine
oil to crankcase. See engine
manual for oil specications.
• Dirty or contaminated fuel lter. • Replace fuel lter.
• Dirt, water, or stale fuel is in
fuel system.
• Drain fuel in tank into
an appropriate storage
container and dispose of bad
fuel properly.
• Rell fuel tank with fresh,
clean fuel.
• Empty fuel/water separator
bowl.
• Replace fuel lter.
To Next Page
Loading...
