BOXER 322D - Page 85

Troubleshooting
4
Problem Possible Causes Corrective Action
Engine does not start with
hydraulically powered at-
tachment installed.
• Auxiliary control lever in
activation position.
• Move control lever to Neutral
position.
Rubber track slips on drive
sprocket or comes off
machine
• Track drive tension is not
correct.
• Adjust Track Tension. See
Section 4 – Track Drive
Tension Adjustment.
• Track drive sprocket holes worn
or damaged.
• Replace rubber track.
• Track guide ngers worn,
damaged or missing.
• Replace rubber track.
Starter does not turn the
engine over.
• Auxiliary hydraulics/ Operator
presence lever is either in
Forward or Reverse position
with no hydraulically powered
attachment installed.
• Move lever to neutral
position.
• Battery is dead. • Charge the battery.
• If battery does not hold a
charge, replace the battery.
• Electrical connections are
corroded or loose.
• Check electrical connections
for good contact.
• Remove cables from battery
terminals and fully clean
battery terminals and cable
clamps.
• If the cable clamps cannot
be properly cleaned, replace
connectors.