The central point is only measured to check that these three adjustments have
been made correctly. Witbox 2 comes levelled as standard, so generally, the
knurled wheels should not need to be adjusted. To do this, you would need to
touch the three wheels.
Press the control wheel and select OK to complete the levelling process.
Printing a File with Cura.
Cura is a slicing software and printer host, which has a simple and intuitive
graphical interface and is easy to configure. Using this program, you can get an
idea of how the object will be extruded and the slicing results. You can also
generate the .gcode and send it your 3D printer or copy it to the SD card.
For more information, go to:
www.bq.com/support/witbox-2
Printing Remotely with
Octoprint.
Octoprint is an open source software application which creates a server on your
computer or on devices such as Raspberry Pi, so that you can control your printer
remotely via serial port.
http://octoprint.org
http://goo.gl/gpCvHf
To Next Page
Loading...
