Braeburn 1000NC - Table of User Options; Setting the System Control Mode; Setting the Fan Control Mode

7
User Factory Setting
No. Options Default Options Comments
 1 1ststage 0.5 0.5, 1.0 Selecta1ststagetemperature
   differential   or 2.0 differentialof0.5˚,1.0˚or2.0˚F
       (0.2˚,0.5˚or1.0˚C)
 2 2ndstage
2.0 1.0, 2.0,  Selecta2ndstagetemperature
   differential   3.0, 4.0 , differentialof2˚,3˚,4˚,5˚or6˚F
(1200NCOnly ) 5.0 or 6.0  (1.0˚,1.5˚,2.0˚,2.5˚or3.0˚C)
Table of User Options
Detailed Explanation of User Options:
Temperature Differential
(User Option 1 and 2)
Thedifferentialsettingisthetemperaturecontrolrangethatyourthermostat
willprovide.Thesmallerthesetting,thetighteryourrangeoftemperature
controlandcomfortwillbe.The2ndstagedifferentialisonlyforsystems
withasecondstageofheating(auxiliaryheat).
6
Operating Your Thermostat
Setting the System Control Mode
TheSystemControlhasseveralmodesofoperationthatcanbeselectedby
movingtheSYSTEMswitchtooneofthreepositions.
COOL Onlyyourcoolingsystemwilloperate
OFF Heatingandcoolingsystemsareoff.
HEAT Onlyyourheatingsystemwilloperate.
Additional Switch Position (Model 1200NC Only):
EMER Operatesabackupheatsource(EmergencyHeat)forheatpump
 systemsonly.
NOTE: If your model 1200NC was set to a con-
ventional system (NORM) then you will not have the
EMER (emergency heat) option and “NO AUX SET”
will flash in the display if EMER is selected
with the
system switch.
Setting the Fan Control Mode
The Fan Control has 2 modes of operation – AUTO
and ON. The mode can be selected by moving the
FAN switch to the appropriate position.
AUTO Thesystemfanwillrunonlywhenyour
  heatingorcoolingsystemisrunning.
ON Thesystemfanwillstayon.