Do you have a question about the Brahler DIGIMIC and is the answer not in the manual?
Frequency Response | 20 Hz - 20 kHz |
---|---|
Microphone Type | Condenser |
Impedance | 200 Ohms |
Polar Pattern | Cardioid |
Power Supply | External Power Supply |
Connectivity | Wireless |
Connector | RJ45 |
Type | Digital Microphone System |
Key safety guidelines to prevent hazards and ensure proper use of the equipment.
List of wireless components included in the DIGIMIC system.
List of wired components included in the DIGIMIC system.
Diagram illustrating the basic setup of the wireless DIGIMIC discussion system.
Guidance on how to adjust the transmitting antenna for optimal signal radiation.
Instructions on how to recall the factory default settings for the DSpark unit.
Configuration of the RF power output for different mounting scenarios.
Explanation of the PRIO mode for chairperson/delegate configurations.
Functionality of the LS INTERN setting for audio routing to loudspeakers.
Using the VOX mode for automatic microphone activation by voice.
How to adjust the volume levels of the microphones and loudspeakers.
Table detailing specifications for various radio protocols and their performance.
Steps to transform wired DIGIMIC delegate units into wireless units using the DDoc.
Example configuration for slave mode with wired units and DSpark.
Steps to start the conference system and register units for operation.
Details on the DDoc docking unit's role in single operation mode.
How to check the status of rechargeable batteries via the multicolor LED.
Instructions for charging a single battery pack using an external power supply.
Procedure for charging multiple battery packs using the DTray.
Steps to remove the battery pack from the DDoc unit for charging.
Illustrations and explanations of parallel operation with multiple DIGIMIC systems.
Specifications and description of the TM58/6 conference microphone.
HF, digital, analog, and general properties of the DSpark unit.
Visual representations of the DIGIMIC wireless and wired system configurations.