SMS syntax Description Value legend
PROGNUMTEL1.numtel1.numtel2.
numtel3.numtel4.numtel5.
Setting a block of telephone numbers
from user 1 to 5.
Numtel 1-2-3-4-5: telephone number
of user 1-2-3-4-5.
PROGNUMTEL2.numtel6.numtel7.
numtel8.numtel9.numtel10.
Setting a block of telephone numbers
from user 6 to 10.
Numtel 6-7-8-9-10: telephone number
of user 6-7-8-9-10.
PROGNUMTEL3.numtel11.numtel12.
numtel13.numtel14.numtel15.
Setting a block of telephone numbers
from user 11 to 15.
Numtel 11-12-13-14-15: telephone
number of user 11-12-13-14-15.
PROGNUMTEL4.numtel16.numtel17.
numtel18.numtel19.numtel20.
Setting a block of telephone numbers
from user 16 to 20.
Numtel 16-17-18-19-20: telephone
number of user 16-17-18-19-20.
PROGNUMTEL (PROGNUMTEL1; PROGNUMTEL2; PROGNUMTEL3; PROGNUMTEL4) this makes it possible to program a
block of 5 users/telephone numbers at the same time with one SMS. The feedback of an SMS identical to the one sent
means that the command has been correctly received and implemeted by the Dialler.
The telephone number must be written in the format +39335xxxxxx (the country code must always be indicated).
The example below explains the above table.
PROGNUMTEL1.numtel1.numtel2.numtel3.numtel4.numtel5.
numtel1.numtel2.numtel3.numtel4.numtel5. represent the telephone numbers that must be entered.
Be careful to respect the correct SMS syntax, separating the various telephone numbers with a dot.
The telephone number must be written in the format +39335xxxxxx (the country code must always be indicated).
Once the telephone book settings are complete, the GSM telephone dialler is immediately ready to operate.
If you want to change the default settings related to the Inputs, Outputs and Users, refer to chapters "General information
regarding GSM telephone dialler setting", "Default Parameters" and “Advanced Settings and Commands via SMS”.
SMS commands
The GSM telephone dialler can be remote controlled with regard to address book notification, input activation status
notification, output activation/deactivation and SIM card credit querying.
The available commands are:
SMS syntax Description Answer
RUBR1 Request for the telephone number
memorised for users 1 to 5
SMS
RUBR2 Request for the telephone number
memorised for users 6 to 10
SMS
RUBR3 Request for the telephone number
memorised for users 11 to 15
SMS
RUBR4 Request for the telephone number
memorised for users 16 to 20
SMS
The command RUBR (RUBR1, RUBR2, RUBR3, RUBR4) makes it possible to receive the memorised address book via SMS.
53
Installer's Manual-Dialler use
53
EN
EN
To Next Page
Loading...