Command SMS
In addition to requests regarding credit, the address book and output activation/deactivation, it is also possible to request
the GSM telephone dialler to report or change its own operating status or to report the input status.
Command syntax Description Answer
STATO IMPIANTO
Requests the GSM telephone dialler to
report its own operating status.
Obtaining one of the following
responses via SMS:
Armed (IN),
Partially armed (IP),
Disarmed (DI).
STATO IMPIANTO this is used to request the GSM telephone dialler to notify the user of its operating status.
The available statuses are ARMED and DISARMED for models GSM10, GSM11 and GSM20. In addition, and only for model
GSM21, the PARTIALLY INSERTED status is available. As a response to this request, the GSM telephone dialler sends the user
an SMS reporting the operating status.
The default setting foresees that all inputs are always active (24H). This makes it possible to have the GSM telephone dialler
already ready for operation.
Whenever a different setting is used for the inputs, it may be useful to work with the ARMED-DISARMED logic.
Refer to chapter "General setting information" for a more detailed explanation.
Command syntax Description Answer
STATO INGRESSO
Requests the GSM telephone dialler
to report the activation status of its
inputs.
SMS with the input status.
Stand-by input is defined closed; the
activated input is defined open
STATO INGRESSO this is used to request the GSM telephone dialler to notify the user of input activation.
The available statuses are CLOSED for stand-by inputs and OPEN for activated inputs.
Refer to chapter "General setting information" "inputs" for a more detailed explanation.
Command syntax Description Value legend Answer
ARCE.X. Arm the security system
X can have the following values:
IN if you want to arm the system;
DI if you want to disarm the system;
IP if you want to partially arm the
system (only GSM21)
Ring if OK.
Or SMS
“System not ready”
ARCE this is used to arm, partially arm or disarm the system if the input logic has been changed.
This command is useful for the model GSM21 if you want to use the central functions.
64
Installer's Manual-General setting information
64
EN
To Next Page
Loading...