ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี
โทร: 02-888-3472 โทร (.บบแกออ) :08-08-170-170 กฟแซ์: 02-888-3258
https://www.add-furnace.com E-mail: sales@add-furnace.com
Name: Enter Batch name. Maximum 18 characters are allowed. By default, it’s Batch1
Lot Number: Enter the Lot number. If Auto increment is enabled, then Lot numbers
will be incremented automatically by the recorder say Batch1-1, Batch1-2, Batch1-3
etc.. during every start of a new batch
Jobs: Two events, Start, Stop are available
Start: Start means Jobs that should be done during start of a new batch
Stop: Stop means Jobs that should be done during stop of a batch
Note: When batch control is enabled, then recorder will be in Pause mode by default
initially and it requires Starting of the recorder from the Menu by pressing at
(Menu)- More than “Start”. When recorder is not logging any data, Pause
status shall be shown in the Top right area of the recorder as shown below
How to do the batch control
Press on (“Menu”) , “More”, then “Start”. Batch number will be shown in
the recorder Top area.
To Stop this batch, press on “Menu”, “More”, then “Pause”. It gives a message “Saving
data” and updates batch data in the internal memory of the paperless recorder.
124
To Next Page
Loading...