ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี
โทร: 02-888-3472 โทร (.บบแกออ) :08-08-170-170 กฟแซ์: 02-888-3258
https://www.add-furnace.com E-mail: sales@add-furnace.com
Decimal: Defines the decimal point for the Totalizer
Period: Selects second, minute or hour used for the Totalizer
Unit: Defines the unit of totalizing
Preset: Defines the preset value for the Totalizer.
Low Cut: Defines the Low Cut for the Totalizer.
For ex: If 0.0 is set as Low cut, then, if source channel, AI1 is less than 0.0, then,
Totalizer value will not go to negative.
Event: Total 5 events are supported for each Math channel. Defines the type, Set
point,
Log, Job1 or Job2 & Hysteresis
Type: Select one of options, H, L, HH, LL, Dev+, Dev-, Error
Set point: Defines the set point trigger of Totalizer value to initiate Jobs
and/or Log alarms
Log: Select one of Log Alarm, Log Alarm (Auto Ack.), Log Event
Job1, Job2: various jobs can be configured, 2 jobs for each Totalizer
Hysteresis: To avoid jobs have been activated too often, it can set for no
reaction. Hysteresis value can be defined for the event trigger set point
81
To Next Page
Loading...
Need help?
General