12 Afbinding USA.fm • Page 28Bale press X-series
Steel wire
When the orange finish indicator button lights and thus
indicates that the bale is ready for binding, do the
following:
Press the lit orange finish indicator button so the platen
goes back to the top position.
The orange finished indicator button will now starts to
flash. From this point forward it will not be possible to
interrupt the process, which will be completed with
binding and bale-ejection.
Open the filling door and draw the steel wire across the
bale. Allow the wire to hang out over the edge of the
main door.
Avoid bending the steel wire unnecessarily, since this
will make further handling more difficult.
To Next Page
Loading...
