15 Fejlfinding USA.fm • Page 36Bale press
15 Troubleshooting
If it is not possible to solve the problems using the troubleshooting table, or there are any other
questions, contact the dealer.
The baler cannot start:
Is the baler connected to the supply network?
Is the repair switch set to "0" or OFF?
Has the emergency stop been activated?
Have the baler's fuses blown?
Connect the cable to the supply network.
Set the repair switch to "1" or "ON".
Release the emergency stop.
Replace the fuse with a fuse of the same
amp. (If the problem is recurring, call for
service).
Bottom plate:
Circuit board:
To Next Page
Loading...
