Branson F36r - Camshaft; Injection Pump

2
-
87
42hW-201601
CHAPTER 2 ENGINE3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
2
6.4.7 CAMSHAFT
Apply the lubricating oil on the journal, cam, thrust
bearing.
Assemble the camshaft with turning it.
Assemble the bolts in cylinder block to hold the
cam shaft. (Tightening torque: 2.7 kg•m)
Cam shaft will be damaged if forcibly assemble.
1.
2.
3.
4.
6.4.8 INJECTION PUMP
Assemble the o-ring in fuel injection pump and
it in gear case ange. (Assemble the key radius
type on the fuel injection pump shaft.)
Line up the injection pump gear and ‘B’ mark of
idle gear (See 5.3.9), and then assemble the bolt
and spring washer to hold fuel injection pump
tentatively.
Line up the injection timing of injection pump.
(Reference the section (2).)
Assemble the nuts to hold the fuel injection
pump.
Assemble the support bracket.
1.
2.
3.
4.
5.
ASSEMBLY
1
K25W297A
Disassemble the timing check plug (1) of fuel
injection pump.
Assemble the dial gage. (with the jig)
1.
2.
LINE UP THE INJECTION TIMING
K25W279A
K25W277A