Branson 8050 User Manual

163 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Branson 8050

Operator’s manual

8050 OPERATORS MANUAL (122011).indd 1 1/10/2012 9:36:13 PM

Table of Contents

Questions and Answers:

A
Angie HunterAug 21, 2025
What to do if the motor does not start on my Branson Tractor?
- J
  jasminsweeneyAug 21, 2025
  If the motor of your Branson Tractor doesn't start when you turn the main switch to START, here are a few things to check: * Ensure the clutch is fully depressed when starting. * Check the battery solution level and charge. Fill the battery solution and fully charge the battery if needed. * Make sure the PTO ON/OFF switch is turned off. * Inspect the battery terminals for looseness or corrosion; clean and tighten them, applying grease to prevent rust. * Check the main fuse and replace it if it's burnt out. * If these steps don't resolve the issue, the key switch or starting motor may be defective, and you should contact a dealer for repair or replacement.
W
william40Aug 22, 2025
What to do if the lamps will not turn on in my Branson 8050?
- P
  Peter RussellAug 23, 2025
  If the lamps on your Branson Tractor won't turn on, consider these potential causes: * A burnt-out bulb: Replace the bulb. * A blown fuse: Replace the fuse. * Bad cable contact: Inspect the cable and secure the connection. * Defective switch: Replace the switch. * Poor grounding: Securely connect the grounding cable to the body. * Discharged battery: Charge the battery.
P
Penny MackAug 25, 2025
What to do if the headlamp will not turn on in my Branson 8050 Tractor?
- M
  Mrs. Alexis ThompsonAug 25, 2025
  If the headlamp on your Branson Tractor won't turn on, check the following: * If the bulb is burnt out, replace it. * If the fuse is burnt out, replace the fuse. * If the cable is separated from the socket, inspect the cable.
C
Chelsea SmithAug 26, 2025
What to do if the direction indicator lamp will not operate in my Branson 8050?
- S
  Steven WilliamsAug 27, 2025
  If the direction indicator lamp on your Branson Tractor isn't working, consider these possibilities: * A burnt-out bulb: Replace the bulb. * A blown fuse: Replace the fuse. * A defective flasher unit: Replace the flasher unit. * Poor contact: Inspect and clean the grounding and terminals.
S
Susan JonesAug 27, 2025
What to do if the horn does not sound on my Branson Tractor?
- L
  lopezdavidAug 27, 2025
  If the horn on your Branson Tractor isn't working, check the following: * If the fuse is burnt out, replace the fuse. * If the horn switch contact is in bad condition, inspect the horn switch.
B
Brittany WigginsAug 29, 2025
What to do if the engine is over heated in my Branson Tractor?
- L
  lambertvincentAug 29, 2025
  If your Branson Tractor's engine is overheating, consider the following: * Check and refill the coolant if the level is low. * Inspect the fan belt for slack or damage; adjust or replace it as necessary. * Clean the radiator core if it's clogged. * Ensure the engine oil level is adequate; refill if low. * Reduce the load if the engine is running under too much strain.
C
conleyjenniferAug 31, 2025
Why is the engine power too weak on my Branson 8050?
- C
  Courtney StrongAug 31, 2025
  If your Branson Tractor's engine power seems weak, the following could be the cause: * The air cleaner might be clogged; inspect it. * The nozzle might be stained with carbon; contact the dealer for repair.
S
smithaaronSep 1, 2025
What to do if the motor starts but the engine does not start in my Branson 8050?
- C
  Claudia JordanSep 2, 2025
  If the motor starts but the engine doesn't start in your Branson Tractor, check these: * Make sure the fuel tank isn't empty; fill it up and drain any air from the system. * If the fuel is mixed with air, drain the air from the fuel. * If the engine only runs when the reducer lever is pulled, charge the battery.
P
phillip95Sep 3, 2025
What to do if the engine oil warning lamp is on during operation of my Branson 8050?
- J
  joshuabakerSep 3, 2025
  If the engine oil warning lamp is on while operating your Branson Tractor, check the following: * Ensure the engine oil level is adequate; refill if low. * If the engine oil viscosity is low, replace the engine oil with the one with proper viscosity. * If the pressure switch is defective, replace the switch. * If the oil pump is defective, contact dealer for repair.
E
Elizabeth Mathis MDSep 5, 2025
What to do if the implement cannot be lifted on my Branson Tractor?
- W
  wanghaileySep 5, 2025
  If the implement on your Branson Tractor cannot be lifted, here are some things to investigate: * Ensure the hydraulic stop/slow return control dial is not all the way to the right; turn it to the left. * Check the transmission fluid level and refill if low. * Inspect the intake pipe system for air leaks; tighten the filter case or connection parts, and replace the pipe or O-ring if damaged. * Clean or replace the oil filter if it's clogged. * If the hydraulic pump is defective, or if the control valve is dusty or the O-ring is damaged, contact the dealer for repair.

Branson 8050 Specifications

General

Brand	Branson
Model	8050
Category	Tractor
Language	English

Summary

General Precautions

About Warranty

Warranty Service Information

Details required information for warranty service.

Overview of the Tractor

Tractor Front View Components

Identifies front external parts of the tractor.

Tractor Rear View Components

Identifies rear external parts and hitch components.

Tractor Engine Compartment Components

Identifies key engine and fluid system components.

Functions

Switches and Levers Identification

Identifies key switches and levers on the tractor.

Steering Column Adjustments

Details adjustment mechanisms for the steering column.

Lighting and Safety Switches

Explains the use of emergency and lighting control switches.

Drive System Controls

Describes operation of 4WD selection and shuttle lever.

Dash Meter and Indicators

Explains the dashboard gauges and warning indicators.

Pedals Operation

Identifies clutch, brake, and accelerator pedals.

Control Levers (Right & Left Hand)

Identifies and explains the functions of right and left-hand levers.

Hitch and PTO Controls

Explains operation of rear implement, hitch, and PTO controls.

Other Controls and Features

Lists and introduces various other tractor features like climate control.

Operation & Work

Pre-Operation Checks and Break-in

Outlines checks before operation and new tractor break-in guidelines.

Engine Start and Stop Procedures

Details the procedures for safely starting and stopping the engine.

Safe Driving Practices

Covers safe operation on roads, slopes, and pavement.

Loading, Unloading, and Implement Handling

Outlines safe procedures for loading, unloading, and connecting implements.

Wheel Tread and Power Steering

Explains wheel tread adjustment and power steering system.

Maintenance After Work

Post-Work Cleaning and Greasing

Instructions for cleaning and lubricating after use.

Maintenance for Prolonged Storage

Guidelines for preparing the tractor for long-term storage.

Storage Procedures and Battery Care

Details steps for storing the tractor and battery.

Periodic Maintenance and Adjustment

Maintenance Schedule and Fluid Capacities

Provides a schedule for maintenance and lists fluid capacities.

Engine Oil and Filter Maintenance

Details checking and changing engine oil and filter.

Transmission/Hydraulic Oil and Filter Maintenance

Guides on checking and changing transmission/hydraulic oil and filter.

Front Axle Oil and Coolant Maintenance

Explains front axle oil check and coolant/anti-freeze handling.

Air Cleaner, Battery, and Brake Adjustments

Covers air cleaner, battery maintenance, and brake adjustments.

Hose, Cable, Belt, and Steering Checks

Instructions for checking hoses, cables, belts, and steering wheel.

Wheel Alignment, Fuses, and Exhaust Gas

Details wheel alignment, fuse replacement, and exhaust gas interpretation.

Troubleshooting

Engine Troubleshooting

Provides solutions for common engine starting and running issues.

Engine Performance and Warning Lamp Issues

Addresses engine revolution, overheating, and warning lamp problems.

Clutch and Brake Troubleshooting

Solutions for clutch slippage and brake system faults.

Hydraulic System Troubleshooting

Solutions for implement lifting and lowering problems.

Electrical System Troubleshooting

Addresses issues with lights, horn, and other electrical components.

Specifications

Tractor Dimensions and Weight

Lists overall dimensions, wheel base, tread, and weight.

Engine Specifications

Details engine model, type, output, and displacement.

Transmission, PTO, and Hydraulic Specifications

Covers transmission type, PTO speed, and hydraulic system details.

Related product manuals

Preview: Branson K62

Preview: Branson 6640C

Preview: Branson 3015r

Branson 00 Series

Preview: Branson 20R series

Branson 20R series